Stanbroil Furnace Flame Sensor Igniter Rod - Replacement For Rheem 62-23543-01

Homeowners with Rheem furnaces, this flame sensor is one of those simple parts that can save you from expensive service calls!

When your furnace starts acting up - maybe it's short cycling, not staying lit, or showing error codes - the flame sensor is often the culprit.

This replacement part directly fits Rheem models requiring part number 62-23543-01.

The sensor has a 1/4 inch male quick connect and 90-degree angle offset, matching the OEM specifications perfectly.

Installation is surprisingly simple: just turn off power to your furnace, remove one screw, slide out the old sensor, and install this new one.

The whole process takes about 10 minutes and requires only basic tools.

The premium quality construction ensures reliable performance and long service life.

I replaced mine after my furnace would ignite but then immediately shut off, and this fixed the issue completely.

The sensor works by detecting whether burners have properly ignited - if it doesn't sense flame, it shuts off the gas valve as a safety precaution.

Over time, these sensors can get coated with carbon buildup and stop working properly.

Before calling an expensive HVAC technician, trying this $20 part could save you hundreds.

Just remember safety first - always shut off power and gas before working on your furnace.

The part arrived well-packaged and included clear installation guidance.

This is one of those DIY repairs that feels incredibly satisfying when your furnace starts working perfectly again.